Router Sequencer

Purpose

The Router Sequencer was created for those who need a single momentary switch to cycle a multiple-to-one router through all the inputs.

To Use

To control the router, control group the router's selection buttons to the output of the Sequencer.  Now put the number of input channels of the router into the Divisions field.  Now you can either copy out the Input button or you can Control Group this input to some other button or input (such as a CV input).  Remember to include another input if you have Off Enabled (a 32x1 router with Off Enabled would need 33 divisions, while with Off Disabled would only need 32 divisions.  When the highest router input is reached, the next press of the input button will return the router to the lowest available input (or Off, if it it enabled).

Controls

Input

Input to the sequencer.

Divisions

This is where you enter the number of inputs of the router.  Remember to add 1 to the count if you have Off enabled.

Sequenced Output to Router

This is the value on a scale of 0 to 32767 that will control a router device to bring it to the appropriate input.  Control Group (or control wire) this to the router you desire to control.