CAB 16o

Purpose

The CAB 16o device provides analog exit points for audio signals. The CAB outputs 2 network bundles with its 16 analog outputs. The network bundles can be transmitted by either a CAB 8i, CAB 16i, or a CobraNet Interface using the CobraNet Output Device.

Controls

CAB Link

LED on indicates a valid control link between the MediaMatrix frame and the CAB.

Hardware ID

The 4 digit hex id of the CAB. This needs to match the switch settings on the front of the CAB, and also must be unique for the whole system. Acceptable values are 0001 - FFFF. This setting has nothing to do with the bundle assignment (other than to identify the CAB that the "Network Bundle" control applies to).

Valid Hardware ID

LED on indicates that the Hardware ID entered is within the valid range of available Hardware IDs (0001 - FFFF).

Network Bundle

Enter the network bundle that the CAB 16o should be receiving from. Bundles 1-255 are multicast (broadcast to all) and 256-32767 are unicast (one-to-one broadcast). Unicast (256-32767) bundles are recommended to prevent network congestion.

The upper section's Network Bundle controls the first 8 outputs (Jacks 1-8) and which bundle they are received from. Likewise, the lower section's Network Bundle controls the second 8 outputs (Jacks 9-16).

Receiving

LED on indicates that the CAB is currently receiving the specified network bundle.

Mute

Mutes the analog audio on the respective input channel.

Output Gain

Sets the analog gain for a respective channel.

Full-Scale Output

The output setting for a respective channel. This setting corresponds to a full-scale digital signal.